Enabling and Disabling Events
  • Updated on 05 Mar 2019
  • 1 minute to read
  • Print
  • Dark
    Light

Enabling and Disabling Events

  • Print
  • Dark
    Light

OVERVIEW

After an event has been created, you can stop it from running by disabling it. The event and its configuration details are still available, but the event will not run until it is enabled again.
When an event is selected in the folder data panel, an event's enabled or disabled status displays below the event in the event's details.
To disable an event, navigate to the folderSystem > Jobs and Events > Events , select the event and select Disable Event in the entity actions menu in the lower right. To enable the event, selectEnable Event .

Example

In the example, disable an event, then enable it.
To begin, navigate to the folder System > Jobs and Events > Events and select the event to disable. Select Disable Event in the menu.
disable-event.jpg

Click Yes to confirm the action.
ok33.jpg

The event's status is updated to Disabled . Additionally, the Disable Event option in the entity actions menu has been removed and replaced with Enable Event
Select Enable Event in the menu.
enable.jpg

Click Yes to confirm the action. The event's status is updated to Enabled .
enable-ok.jpg

Was this article helpful?